Address: Economic and Technological Development Zone, Decheng District, Dezhou, Shandong
Hard-tooth surface reducer is used for the transmission device with the output shaft in the vertical direction. The gear shaft refers to the mechanical part that supports the rotating part and rotates with it to transmit motion, torque or bending moment.It is generally a round metal rod, and each segment can have a different diameter.Then...
Cycloidal pinwheel reducer is a fresh transmission system that uses the basic principle of a large planetary transmission system and selects the cycloidal pin gear.All transmission systems can be divided into three parts: input part, speed reduction part and output part.Equipped with a shift on the typing axis...
Before starting the gear reducer, press to check whether the oil level in the reducer meets the requirements.Follow the prompts to turn on or change the breather cap to make it ventilate smoothly, and check whether the roll is maneuverable.Before the load test, run for about half an hour with no load, and confirm that the no-load and no end barriers can be loaded...
Precautions for adding lubricating oil to the screw jack.The screw jack is composed of worm gear, box, bearing, screw and other parts.The working principle is: the motor may manually drive the worm to rotate, the worm drives the worm wheel to decelerate and rotate, and the inner cavity of the worm wheel is processed...
Precautions for worm gear screw lifts for 24 hours before leaving the factory: Normally, the running-in phase of worm gear screw lifts after leaving the factory is about 24 hours. During the running-in phase, attention should be paid to stable operation to avoid unnecessary misoperation.And when the worm gear screw rises and falls...