Address: Economic and Technological Development Zone, Decheng District, Dezhou, Shandong
What are the faults and elimination methods of hard tooth surface reducer?The reducer heats up and leaks oil.In order to improve the power of the worm gear reducer, non-ferrous metals are generally used as the worm gear, and the worm is made of harder steel because it is a sliding friction transmission. During the operation...
The causes of gear reducer coupling defects mainly include the following two aspects: lack of oil or lack of oil in the coupling of lifting parts.Or the improper use of grease results in calcification of the grease, causing the tooth surfaces to not be smooth, or the tooth surface is not smooth enough, and the tooth surface wears severe...
Precautions before the device The shaft of the device should be cleaned before using the machine.And check whether there are bumps or dirt on the shaft of the device.The operating temperature of the reducer is 0-40 ℃.Check the fit of the hole (or shaft) connected with the reducer...
Cycloidal pinwheel reducers must comply with certain standards and be properly applied under the specified standards during the entire process of specific application.In addition, problems such as grease, working voltage, and application site must also be considered.Cycloidal pinwheel reducer is composed of three parts, namely...
As a new type of transmission system, the cycloidal pinwheel reducer is based on the basic theory of the large planetary transmission system. It completes the operation according to the gearing of the pinwheel and is composed of input, output, and speed reduction equipment. It consists of three parts, only the three...